Draining Inground Pool Using Garden Hose

Introduction

When an inground pool needs to be drained of water, it can be a difficult job. If you find yourself in this situation and you need to know how to drain an inground pool with a garden hose, you've come to the right place. Draining an inground pool with a garden hose requires more than just snaking a hose through a drain hole. This article will introduce 8-12 relevant topics to help you successfully drain your inground pool with a garden hose.

1. Pre-Drain Prep

Before draining your pool, you will need to make sure the pool is properly prepped. This includes dropping the water level to below the skimmer, disconnecting the pump, and turning off any automatic cleaners. Doing so will help prevent any damage to the pool equipment.

2. Identify the Low-Point

It is important to identify and mark the low-point in the pool. This will be the spot where the most significant amount of pool water is able to freely drain. It is best to fill the low-point with a marker like a buoy or small toy, so that when the pool is drained of water it will not fill with tons of dirt or debris.

3. Locate the Drain Plug

The drain plug serves as the spout for draining a pool. It is important to find the plug before draining the pool. It should be on the side of the pool that corresponds with the low point. If you are unable to locate the drain plug, you may need to consult the manual that came with the pool.

4. Unplug the Drain Plug

Now it is time to unplug the drain plug. It is important to be sure your unplugging the correct outlet. In most cases, it will have labeling by the plug that reads drain. To unplug it, simply twist counterclockwise with your hands.

5. Output Hole

Once the plug has been unplugged, you will need to locate the output hole. This is the part of the pool that the hose will be inserted into to connect it to the spout. If your pool does not have a preexisting hole, you can cut one into the pool with a utility knife and get the job done.

6. Connect the Hose to the Output Hole

Now that you have both your output hole and the hose, it is time to connect them together. Simply thread the hose into the output hole and use a hose clamp to secure the connection.

7. Connect the Garden Hose to the Output Hole

This is the final step. To do this, simply attach the garden hose to the output hole and use a hose clamp to secure the connection. This will allow the water to drain out of the pool into the garden hose.

8. Be Vigilant

Once the water has started to drain, it is important to be vigilant. Check the garden hose periodically to ensure the water is draining properly and that none of the water is backing up into the pool.

9. Clean Up

Once the pool has been drained, it is important to clean up. Make sure that the drain plug is still unplugged, the hose is removed from the output hole, and the garden hose has been disconnected.

10. Refill the Pool

When you are ready to refill the pool, simply attach the garden hose to the fill spout and turn it on. It is important to keep an eye on the water level throughout this process. Allow the water to fill to a few inches below the pool edge before turning off the hose.

11. Plug the Drain Plug

Once the pool has been filled, it's time to plug the drain plug. This can be done by simply twisting the plug in a clockwise motion.

12. Final Check

Once the drain plug has been plugged, it is important to give the pool a final check. Make sure that the water is full, the plug is secure, and the connections are all sealed.

Summary

Now that you know how to drain an inground pool with a garden hose, it is important to follow the steps outlined in this article. Doing so will not only save you time and energy, but will also help to ensure that your pool is drained safely and properly.